محبوبترین نویسندگان :
نویسندگان مقالات پربازدید :
مواد و طراحی
جزئیات رویداد
همایش ، رویداد ، ژورنال
اینستاگرام تی پی بین
حوزه های تحت پوشش رویداد

  • the wear rates and performance of three mold insert materials

    نویسندگان :
    کلمات کلیدی :
    جزئیات بیشتر مقاله
    • تاریخ ارائه: 1390/01/01
    • تاریخ انتشار در تی پی بین: 1390/01/01
    • تعداد بازدید: 510
    • تعداد پرسش و پاسخ ها: 0
    • شماره تماس دبیرخانه رویداد: -
     in this study, a rapidly solidified aluminum alloy was compared with beryllium copper and 6061 aluminum alloys in terms of their wear rates, hardness and performance as mold insert materials. a vickers hardness measuring machine and a tribometer were used to determine the hardness values and wear rates of the materials. three sets of mold inserts were made of these materials, and the insert surfaces and the molded plastic lens surfaces were characterized using a scanning electron microscope and a surface profilometer, respectively. the investigation results indicate that the becu alloy has the lowest wear rate, while aluminum 6061-t6 has the highest wear rate. although the rapidly solidified aluminum alloy is not as hard as the becu alloy, the differences between their wear rates and hardness values are not as great as the differences between aluminum 6061-t6 and the becu alloy. the results also indicate that the rapidly solidified aluminum alloy performs much better than aluminum 6061-t6 in molding of plastic lenses and is comparable to the becu alloy. it is able to attain finer surfaces of the molded plastic lenses. this is an important finding, and this means that the rapidly solidified aluminum alloy can replace the becu alloy as a good mold insert material, because beryllium (be) is a toxic element. the finding gives the industry a better choice for selection of mold insert materials.

سوال خود را در مورد این مقاله مطرح نمایید :

با انتخاب دکمه ثبت پرسش، موافقت خود را با قوانین انتشار محتوا در وبسایت تی پی بین اعلام می کنم
مقالات جدیدترین رویدادها
مقالات جدیدترین ژورنال ها